ADB Safegate CRE 10, Руководство по установке

Страница: 65 / 86

A.07.370e - Edition 2.0 65
Technical data
7 Technical data
7.1 Specifications
Table: 7.1 Technical specifications
Table: 7.2 Output specifications
Item Description
Rated input voltage [V] 400 V AC (± 10%) single phase
230 V AC (± 10%) single phase
Rated frequencies [Hz] 50 or 60
Current regulation limits Current regulation is guaranteed under the following conditions (± 0.1 A):
- Under IEC 61822 environmental conditions
- For nominal input voltage under IEC or FAA standard conditions
- From full load to short circuit
Current regulation modes Two preset regulation modes:
- normal mode (for linear loads)
- inductive mode (for non-linear loads (e.g. LED loads)
Average efficiency at full
load 92 to 94% depending on the size of the equipment, under nominal resistive
load, nominal output current and nominal input voltage
Power factor at output The power factor exceeds the IEC and FAA requirements. The power factor at
rated load is close to 1 and is kept at high level for any possible operational
conditions.
Brightness steps 5 standard, 8 maximum, fully adjustable in 65k levels (1mA resolution)
Output current [A] 6.6
Remote control and
monitoring - Multiwire: 24 VDC and 48 VDC to 60 VDC
- Single or dual J-Bus protocol over 2-wire RS485.
- Single or dual J-Bus protocol over Ethernet IEEE 802.3
Regulation response time - Less than 0.3 seconds
- Exceeds the requirements of IEC 61822
Open circuit ouput voltage Less than 1.2 times the nominal output voltage (RMS)
Ingress protection IP 21
Type Rated output
power [kW] RMS output voltage
at 6.6 A RMS output
current [kV] Insulated test on
output
1
[kV]
Output overvoltage
protection 25kApk
CRE 2.5 2.5 0.38 3 0.75 kV
RMS
, 1.4 kJ
CRE 4.0 4.0 0.60 5 1.5 kV
RMS
, 2.8 kJ
CRE 5.0 5.0 0.75 5 1.5 kV
RMS
, 2.8 kJ
CRE 7.5 7.5 1.13 6 2.2 kV
RMS
, 4.2 kJ