3-7
Installing the Driver
4
Shut down the system and remove the
Adaptec RAID
Installation CD
and the driver floppy disk.
5
Insert the Windows NT setup media (floppy disk or CD) and
restart the system.
6
If prompted, skip Setup’s mass storage detection. Press
S
to
Specify Additional Devices.
7
Select
Other
, then insert the driver disk you created in
Step 3
.
8
Select
Adaptec I
2
O RAID Host Adapter Driver for NT 4.0
.
9
Press
Enter
and continue with the installation as described in
the Windows NT documentation.
Installing the Driver in a New System with Other Hardware
In this scenario, you are installing an Adaptec RAID controller in a
new computer system with another controller from another
manufacturer or other hardware that requires the use of
Windows NT mass storage detection. To install the driver
1
Create a driver disk using the
Adaptec RAID Installation CD
. To
create a driver disk
a
Insert the
Adaptec RAID Installation CD
in your drive.
b
Boot from the CD. The CD loads a Linux kernel that is used
to manage all of its functions.
c
Follow instructions and respond to prompts as necessary to
get to the Adaptec splash screen.
d
When you see the Adaptec splash screen, click
Create
Driver Disk
. Then, click the appropriate operating system.
e
Insert a floppy disk and click
OK
. The system creates the
driver disk.
2
Shut down the system and remove the
Adaptec RAID
Installation CD
and the driver floppy disk.
3
Install and configure your Adaptec RAID controller and hard
drives according to the instructions in
Chapter 2
.
Содержание 2100S - SCSI RAID Controller
Страница 1: ...R AdaptecRAID Installation Guide ...