ActronAir PKV160T, Руководство по установке и пусконаладке

Страница: 55 / 60

Installation and Commissioning Guide
Variable Capacity Commercial
55
Installation and Commissioning Guide- Package Ducted Variable Capacity Commercial
Doc. Part No. 0525-076 Ver. 3 210414
OUTDOOR SECTION
Parts
Service Period
Detail of Service Check Service Methods
1
Mth
3
Mths
6
Mths
1
Yr
2
Yrs
3
Yrs
4
Yrs
5
Yrs
Casing / Panels
and Frames

Visual check for damage, rust
and dust accumulation.
For highly corrosive
environment, wash panels
quarterly with water and neutral
detergent solution. Wax panels.
Repair / re-paint where required.
Insulation 
Visual check for insulation
conditions.
Repair / replace insulation
material.
Fan 
Visual check for run out of
balance and dust attached
Clean off dust as necessary to
negate possibility of fan running
out of balance
Motor

Ω
Visual check on wiring.
Insulation resistance check
to be carried out annually
Measure insulation resistance
to earth with insulation tester.
Insulation resistance should be
more than 1MΩ.
Heat
Exchanger

Check for clogging by dust.
Check for leaks / damage.
Clean air inlet side as necessary.
Straighten any bent fins using
fins comb.
Condensate
Drain Line
(if available)

Check for obstructions and
free flow of water
Clean to eliminate obstructions/
sludge and check condition of
drain line. Pour water to ensure
free flow.
Compressor

Ω
Check for high / low
pressure. Measure
insulation resistance. Check
compressor for abnormal
noise/vibrations
Measure insulation resistance.
Should be more than 1MΩ.
Refrigeration
Operational
Readings

Make note of operational
reading in test cool/heat
Check operating pressures,
record superheat and subcooling
values
Safety
Devices

Check calibration of safety
devices such as HP and LP
controls, sensors, etc
Check resistance of sensors,
pressure cut in / cut out of
pressure controls
Faults 
Check for any previous fault
history on unit.
Investigate any causes for
previous faults, reset fault
history.
Outdoor
Fan Speed
Capacitor

Check for any bulge on the
capacitors & capacitance.
Make it electrically safe prior
to measure the capacitor
capacitance. Measured
capacitance should be with in
the printed tolerances on the
capacitor.