ActronAir PKV160T, Руководство по установке и пусконаладке

Страница: 14 / 60

Installation and Commissioning Guide - Package Ducted Variable Capacity Commercial
Doc. Part No. 0525-076 Ver. 3 210414
Installation and Commissioning Guide
Variable Capacity Commercial
14
PROCEDURE:
1. Remove all screws and washers that secure the unit to the timber pallet.
2. Use 4 x Bow or Dee shackle to connect the lifting holes.
3. Slip nylon slings through all shackles.
4. Ensure slings are protected by rubber pads or similar if slings are draped across the unit edges and corners. This will
prevent the unit from being damaged during lifting.
5. SPREADER BAR must be used when lifting the unit.
DANGER
Make sure rigging equipment, accessories and plant are sufficiently and safely capable to lift the unit in order to prevent
potential damage to property, severe personal injury or death. Check unit weight and weight distribution points on unit
drawing dimensions section.
NOTES
• Lifting procedure and unit model shown are suggestions and for illustration purposes only.
• It is highly recommended that installer observe current industry safe and sound rigging and lifting procedure.
CAUTION
Length of fork lift tines must pass the unit middle section, in order to safely carry the unit.
Fork Lift Method
Procedure:
1. To move the unit around with a forklift, insert the fork tines through the unit feet assembly, as shown in Fig. 2.
2. Only fork the unit through compressor end or side of the unit.
(See illustration for location of compressor end)
CAUTION
DO NOT LIFT from this end
Fig. 2
COMPRESSOR
END
INSERT FORKLIFT
TINES HERE