Acopia Adaptive Resource Switch, Руководство по обслуживанию CLI

Страница: 179 / 324

Troubleshooting Network Connections
Pinging an IP Address
CLI Maintenance Guide 7-5
8 bytes from 10.53.2.10: icmp_seq=4 ttl=0 time=100 ms from 3.3
8 bytes from 10.53.2.10: icmp_seq=5 ttl=0 time=100 ms from 3.3
8 bytes from 10.53.2.10: icmp_seq=5 ttl=0 time=100 ms from 3.3
-------10.53.2.10 ping statistics
6 packets transmitted, 6 packets received, 0% packet loss
round-trip min/avg/max 1/1/3 ms
bstnA6k>
...
Sending an Alternate Source IP
You can use an alternate source-IP address in a ping. By default, the source IP is
calculated based on the originating processor’s routing table.
There are three types of internal IP addresses that you can use as sources for ping:
proxy IPs, Virtual IPs, and management IPs.
• The network processors use proxy-IP addresses to communicate with servers.
Use the
show ip proxy-addresses
command (see “Showing all Proxy IPs” on
page 4-7 of the CLI Network-Management Guide ) to list all proxy-IP addresses.
Each network processor is assigned its own proxy-IP.
• The network processors use virtual-IP (VIP) addresses to communicate with
clients. Use the
show global server
command (see “Showing All Global Servers”
on page 10-11 of the CLI Storage-Management Guide ) to list all VIPs.
• There are two types of management interface: one in-band interface for each
VLAN and one out-of-band (OOB) management interface. Use the
show
interface vlan
command to list all VLAN-management interfaces (see “Listing all
VLAN Management Interfaces” on page 4-6 of the CLI Network-Management
Guide ). Use
show interface mgmt
to find the source address for the OOB Mgmt
interface (see “Showing the Interface Configuration” on page 4-22 of the CLI
Network-Management Guide ).
If you set a source IP without setting the source processor, the source IP determines
the processor. For example, if you choose the IP for the out-of-band management
port, the CLI sends the ping from the SCM processor.