Acer ATL 1820E, Руководство по эксплуатации

Страница: 17 / 76

Page 1-12
10) While a work piece is turning, do not wipe it off or remove chips with a cloth
or by hand. Always stop the machine first and then use a brush and a
sweeper (for machine).
11) Do not operate the machine with safety front guard and chuck covers
opened.
12) Use a brush to remove chips from the tool tip not bare hands.
13) Stop the machine whenever installing or removing a tool.
14) Whenever machining magnesium alloy parts, wear a protective mask.
CAUTION
1)
The machine could not open under automatic operation. Also, the machine
front guard can’t be opened under automatic operation model.
2)
When performing heavy-duty machining, carefully prevent hips from being
accumulated since hot chips can catch fire.
1.4.6 To interrupt machine
WARNING
When leaving the machine temporarily after completing a job, turn off the
power switch on the operation panel, and the main circuit breaker.
1)
When leaving the machine temporarily after completing a job, turn off the
power switch on the operation panel, and the main circuit breaker.
2) When being a sudden power failure in the processing state, turn off the power first.
Then open the right cover put the L-wrench into the screw end of the Z-axis at the
reverse exit from the work piece as shown as figure.
The screw end
of Z-axis ball
screw