Abov MC97F60128, Руководство пользователя

Страница: 363 / 382

363
MC97F60128 ABOV Semiconductor Co., Ltd.
The Byte Write program procedure in user program mode
1. Page buffer clear (FMCR=0x01)
2. Write data to page buffer
3. Set flash sector address register (FSADRH/FSADRM/FSADRL).
4. Set flash identification register (FIDR).
5. Check the UserID for to prevent the invalid work
(Note1)
.
6. Set flash mode control register (FMCR).
7. Erase verify
NOTE)
1.
Please refer to the chapter “Protection for Invalid Erase/Write”.
2.
Data of the address should be “00H” before writing data to an address.
3. On flash memory erase and write, it should be disabled the RXE bit of USInCR2/UARTnCR2
register.
Program Tip
–
byte write
ANL EO,#0xF8 ;Set DPTR0
MOV FMCR,#0x01 ;page buffer clear
NOP ;Dummy instruction, This instruction must be needed.
NOP ;Dummy instruction, This instruction must be needed.
NOP ;Dummy instruction, This instruction must be needed.
MOV A,#5
MOV DPH,#0x80
MOV DPL,#0
MOVX @DPTR,A ;Write data to page buffer
MOV A,#6
MOV DPH,#0x80
MOV DPL,#0x05
MOVX @DPTR,A ;Write data to page buffer
MOV FSADRH,#SAH ;Sector Address High Byte. If used BANK1,SAH is 1.
MOV FSADRM,#SAM ;Sector Address Middle Byte
MOV FSADRL,#SAL ;Sector Address Low Byte
MOV FIDR,#0xA5 ;Identification value
MOV A,#ID_DATA_1 ;Check the UserID(written by user)
CJNE A,UserID1,No_WriteErase;This routine for UserID must be needed.
MOV
A,#ID_DATA_2
CJNE A,UserID2,No_WriteErase
MOV FMCR,#0x03 ;Start flash write mode
NOP ;Dummy instruction, This instruction must be needed.
NOP ;Dummy instruction, This instruction must be needed.
NOP ;Dummy instruction, This instruction must be needed.
LJMP Write_verify
---
No_WriteErase:
MOV FIDR,#00H
MOV UserID1,#00H
MOV UserID2,#00H
---
Write_verify:
---
Verify_error:
---