BUSCH-/ABB-SECURE@HOME
2CSM600727D0901
67/74
13.2.2
SIM Replacement
To replace the SIM, place the system in maintenance mode and check the installation sheet
contained in the central unit packaging.
13.2.3
Replacing the detector battery
To replace the detector battery:
1.
Put the system into service.
2.
Open the detector, replace the used battery and close it again according to the
instructions provided in the sensor manual.
3.
Perform a system test on the detector to verify its proper operation.
13.2.4
Replacing the remote control battery
To replace the battery of a remote control
1.
Open the remote control, replace the battery and close it again according to the
instructions provided in the device manual.
2.
Enter the System Test menu and press any key on the remote control.
3.
in the rest window and check that the device is working properly.
13.2.5
Replacing the siren battery
1.
Enter the System Test menu and perform the siren test procedure as described in the
dedicated section.
2.
From now on, you have 5 minutes to open the siren without causing it to sound
tampered with.
3.
Open the siren according to the instructions in the manual, replace the old battery
and close it again.
4.
Afterwards, perform a siren test procedure again to check that it is working properly.
13.2.6
Central unit reset
To restore factory settings for the central unit, deleting all programming operations and
configurations performed:
1.
Log in as a level 2 user, go to the installer screen and log in as a level 3 user: select the
Maintenance icon.
2.
Log in as a level 4 user. If no level 4 users exist, the central unit will ask you to create
one.
3.
When the screen appears, press 2 Factory reset.
After a factory reset, the central unit generates a new encryption key.
WARNING!
The central unit reset operation cannot be reversed, and involves a new, full
configuration of the system.
