BUSCH-/ABB-SECURE@HOME
2CSM600727D0901
49/74
12.2.2
To modify or delete a zone:
Select the desired zone.
A video appears offering the option to view the sensors programmed for the zone.
Select:
-
Rename to modify the zone label
-
Delete to delete the zone
12.2.3
To programme a sensor:
-
Repeat points 1-3 of paragraph 12.2.1
-
Select New Device: the central unit is waiting, get the central unit to discover the
detector by following the instructions included with the device: the detector
continues to wait for the parameters for 5 minutes before going into "low power
consumption" mode
-
When the device has been obtained, the following video will appear:
The list of parameters spans multiple pages. Use the arrow keys to scroll the pages.
The parameters displayed in normal characters, rather than in bold, are read-only.
These are:
-
Address
: hexadecimal address of the detector.
-
Type
: generic name of the detector.
-
Signal
: detector radio signal level, measured in dBm (decibel mW).
-
Repeater
: ID of the repeater used, if the detector does not communicate with
the central unit directly, but rather via the repeater. "Not set" means that the
detector communicates directly with the central unit.
Configure the parameters. The table in the subsequent paragraph lists all of the
parameters for the detectors, their meaning and their possible values. Use the arrows
to select the desired value from among the available values.
-
Press Save or ok key to save the configuration.
-
Associate the sensor with a zone.
WARNING!
The technological sensors are automatically assigned by the system to a
technological zone.
New Device
Waiting for the
device...
Finish Setup
Label:
[ ]
Address:
F831CB41
Type :
External IR
Signal:
-36 dbm
