ABB SACE Tmax XT5, Руководство по эксплуатации и обслуживанию

Страница: 132 / 205

ABB | SACE Tmax XT
130 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A External accessories | 2 - Ekip Cartridge
2 - Ekip Cartridge
Ekip Cartridge is an external accessory. It can be installed on standard 35 mm DIN rail (DIN EN 50022 type
TS 35x15 mm) and allows Ekip Touch to be connected to other external accessories:
• all cartridge modules (e.g.: Ekip Supply, Ekip Com, etc)
• contact for signaling racked-in/racked-out state, in the case of withdrawable CBs
Models
The two different models available allow two or four modules to be connected, respectively.
IMPORTANT: one of the modules must always be Ekip Supply
Connections
Ekip Cartridge has two terminal boxes:
Figure 39
Connector Description
1
Terminal for connecting the racked-in/racked-out status contact.
NOTE : Ekip Cartridge is supplied by default with a jumper on the terminal
To use the racked-in/racked-out status signal, remove the jumper in the connector
and connect the cables from the fixed part of the CB.
2
Terminal for connecting Ekip Cartridge to Ekip Touch.
A list and description of the Pins is given below:
• K2: Supply output for Ekip Touch (+24V DC)
• K1: Supply output for Ekip Touch (-24V DC)
• W3: CAN Bus
• W4: CAN Bus
Access to all the external connections is available in the respective modules, on the upper side of
Ekip
Cartridge .
Mounting
To connect the module to Ekip Touch, please consult document 1SDH002009A1503 .