ABB IRB 390, Руководство по эксплуатации продукта

Страница: 323 / 346

7.2 Oil and grease stains on motors and gearboxes
Description
The area surrounding the motor or gearbox shows signs of oil leaks. This can be
at the base, closest to the mating surface, or at the furthest end of the motor at the
resolver.
Consequences
Besides the dirty appearance, in most cases there are no serious consequences
if the leaked amount of oil is very small.
Possible causes
The symptom can be caused by:
• Leakage of rust preventives or mounting grease. This should be wiped off.
• Leaking sealing between gearbox and motor.
• Gearbox overfilled with oil.
• Gearbox oil too hot.
Recommended actions
The following actions are recommended:
Information Action
CAUTION
Allow hot parts to cool down.
1
If the oil spill is small, this step is
sufficient. Wipe off the oil or grease, see Cleaning the IRB
390 on page 116 .
2
Monitor the robot over time to see if new oil or
grease occurs.
Check the gearbox oil level. 3
Robots performing certain, ex-
tremely heavy duty work cycles
may be fitted with vented oil plugs.
These are not fitted to normal duty
robots, but can be purchased from
your local ABB representative. Too hot gearbox oil may be caused by:
• Incorrect oil quality or level.
• The robot work cycle runs a specific axis
too hard. Investigate whether it is possible
to program small "cooling periods" into the
application.
• Overpressure created inside gearbox.
4
Inspect all sealings and gaskets between motor
and gearbox. Replace broken parts. 5
Product manual - IRB 390 323
3HAC066566-001 Revision: B
© Copyright 2020 - 2021 ABB. All rights reserved.
7 Troubleshooting
7.2 Oil and grease stains on motors and gearboxes