ABB DressPack IRB6650S, Руководство по эксплуатации продукта, Страница: 221 / 390

PROC 2 on robot base C
PROC 3 on robot base D
Shop water supply E
Shop water drain F
PROC 4 on robot base (option) G
Required equipment
Note Article number Equipment
The contents are defined in sec-
tion
Toolkits, DressPack/Spot-
Pack on page 355 .
3HAC17290-7 Standard Toolkit, DressPack/SpotPack
General inspection
The procedure below describes how to perform a general inspection of the Water
and air unit.
Note Action
Clean if required as detailed in section
Cleaning, Water and air unit on page 226 .
Check that the Water and air unit is not
contaminated. 1
Recommended tightening torques are
specified in section
Tightening torque on
page 351 .
Check that the bolts are fastened. 2
Retighten if necessary. Check that all connections are correctly
made and that there are no leaks.
CAUTION
Do not tighten the brass couplings for water
and air with excessive force.
3
Tightening torque, brass couplings 1/2":
31 Nm
Tightening torque, brass couplings 3/8":
17 Nm
Inspection, air supply circuit
The procedure below describes how to inspect the air supply circuit.
Note Action
If there is a lot of water in the filter recept-
acle, this is a sign that the supplied air
consist of too much water. Check if there is water in the filter recept-
acle.
Normally the filter receptacle is drained
automatically in case of a fall of air pressure.
If there is no fall of pressure in the air sys-
tem, there is an automatic draining of the
system, when the water level reaches a
certain level. 1
If this is the case, steps must be taken to
correct this problem!
Drain the air filter receptacle manually by
pressing a small pin at the bottom of the air
filter unit. 2
Retighten if necessary! Make a check that there is no leakage. 3
If needed replace the air filter. Make a check of the condition of the air filter. 4
Normally the filter should be replaced
after one year of use.
Continues on next page
Product manual - DressPack/SpotPack IRB 6650S 221
3HAC055424-001 Revision: C
© Copyright 2004-2018 ABB. All rights reserved.
3 Maintenance
3.3.3 Preventive inspection of Water and air unit
Continued