DBC 225
FOR
MX-ONE
78
4/1553-ANF 901 54 Uen D4 2014-01-14
7.2.5
Cancel manual message waiting indication
To cancel manual message waiting to another extension
•
Lift the handset (dial tone).
•
Dial #31*extension number#.
•
Replace the handset.
To cancel manual message waiting at own extension
•
Lift the handset (dial tone).
•
Dial #31#.
•
Replace the handset.
7.3
Recorded voice announcement
7.3.1 Introduction
This section describes the programming procedures to record, play or
erase the RVA message stored in the VSU board.
Before the programming procedure can be started, a voice directory
number has to be assigned to a VSU board via the I/O command. After
that, this directory number can be called from a DTS or from a PBX oper-
ator assistant console. After the connection, the voice messages in the
VSU board can be recorded, played or deleted.
When a PBX operator assistant calls the directory number, the end to
end DTMF mode has to be entered manually. The programming proce-
dures are the same as those for the DTS.
Note:
No text message will be displayed on the PBX operator assistant
console.
In the programming session, the message number is in the range 1-250.
7.3.2
Voice programming initiation
When the programming session is established, the text message,
Ready!
, is displayed.
From then on, you can enter a procedure, either to play, erase or record
a message.