DBC 225
FOR
MX-ONE
118
4/1553-ANF 901 54 Uen D4 2014-01-14
11.6
Headset preset function
Headset Preset
By default the telephone is set for calls to be connected to the loud-
speaker when you answer or make calls by pressing a Line key, so
called Loudspeaker Preset. Also when you dial the number without lifting
the handset, the call is automatically connected to the loudspeaker.
When you use a headset for your telephone, you can change the setting
to get calls connected to the headset instead, so called Headset Preset.
Note:
Independently of the type of preset setting, when you lift the
handset the call is always connected to the handset.
Also handsfree and loudspeaking work as usual, that is, when the
Loudspeaker key is pressed, the call is temporarily connected to
the loudspeaker.
Activation and cancellation of Headset Preset can only be done
when the telephone is in idle mode.
Headset Preset can be activated and canceled either by use of the
headset and loudspeaker keys, or via the top menu
PhoneSet
.
To activate using the top menu PhoneSet:
•
Select the top menu function
PhoneSet
.
•
Frame the menu
Headset Preset
and press the soft-key
Select
.
A tone signal is heard, and the display shows:
Note:
The soft-keys are only available when firmware revision R3F or
later is active for the telephone. See Firmware indication to check
the firmware revision. For earlier version the settings is automat-
ically changed every time the Headset Preset menu is entered.
11.10 Firmware indication on page 122
•
Press the soft-key
Change
to switch to Headset Preset-
Off
is
replaced by
On
.
•
Press the soft-key
Save&Exit
, or press
#
to finish setting.
The headset key lamp flashes for some seconds. The headset symbol is
displayed to indicate Headset Preset.