Aanderaa DCPS 5400, Руководство по эксплуатации

Страница: 27 / 150

July 2019 – TD 304 OPERATING MANUAL – Doppler Current Profiler Sensor Page 27
Select Profile
Parameters
ENUM 1
Different groups of parameters that will control the output from sensor. If
User Specified is selected you may select the individual parameter
under User Specified – Profile Parameter. For all other selections the
individual setting will be overruled by the group setting. Alternative
choices are: Simple Output, Basic Output, Basic + Beam Output, Basic
+ 3-beam Output, Basic + Beam + 3-beam Output, Full Output, User
Specified. See
Table 2-1
or
Table 3-1
for definition of each group.
SC No /
Low
Enable 4-
beam Auto
Replacement
BOOL 1 Enables automatic replacement of the standard 4-beams calculated
result with the best 3-beams if any disturbance in one of the beams.
NE Speed
Output
ENUM 1
Enables/Disables output of calculated North and East speed
components.
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
3-Beam
Combination
Output
ENUM 1
Enables output of the four 3-Beam combinations.
5)
Each 3-Beam is
calculated using only 3-transducers to help detect any obstructions in
one of the beams.
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
AutoBeam
Output
ENUM 1
Enables output of the autobeam solution; the sensor uses a specific
algorithm to define, for each cell and ping, the best beam solution
automatically, based on the use of 3 or 4 beams depending on
disturbance.
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
AutoBeam
Speed Type
ENUM 1
Sets the AutoBeam Speed Type. If AutoBeam Output is selected then
AutoBeam Speed Type will select the output format.
‘Polar’, ‘Rectangular ‘or ’Polar+Rectangular‘, See chapter 2.4.10 or
3.6.11
Vertical Speed
Output
ENUM 1
Enables output of calculated vertical speed
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
Strength
Output
ENUM 1
Enables the output of signal strength (Average from all beams).
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
Beam Speed
Output
ENUM 1
Enables output of speeds for each individual beam (m/s).
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
Beam
Strength
Output
ENUM 1
Enables output of signal strength for each individual beam (dB).
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
Std Dev
Speed Output ENUM 1
Enables standard deviation output for horizontal speed calculated in
each cell.
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).
Std Dev Beam
Speed Output ENUM 1
Enables standard deviation output of beam speed for each beam in
every cell.
5)
‘Off’ or ‘Output’ (in AiCaP Off, Storage or Storage).