a2b Obree, Руководство пользователя

Страница: 52 / 80

52
Owner’s manual
6.3.3 Switch-on of the battery
If the battery has been used within 48 hours, it does not have to be
switched on. The Pedelec is operable and can be switched on via
the sMMI and started.
If the battery is started for the first time or if it has not been used for
more than 48 hours ("Deep Sleep mode"), it must be switched on.
•
Briefly press the button.
•
All LEDs [5] flash three times to indicate that the battery has
been switched on.
•
Your Pedelec is operable now and can be switched on via the
sMMI and started.
If the motor cable has not yet been connected to the battery, the
battery will still be put into "Active mode" when switched on.
If the battery cannot be switched on, the cell voltage might be
too low. In this case, connect the charger and then press the on/off
button. Then, the battery will be charged for a minute.
6.3.4 Display of the state of charge
You can check the battery's state of charge at any time using the
LED display.
If the battery has not been used for more than 48 hours:
•
Briefly press the button.
•
The battery is switched on, all LEDs (a to e) flash three times.
•
Briefly press the button again.
•
Now the LEDs indicate the battery' s capacity as shown in the
following table.
•
If the battery has been used within the past 48 hours:
•
Briefly press the button.
•
Now the LEDs indicate the battery' s capacity as shown in the
following table.
In travelling operation or in case of storage
•
100-81% ROC: LED1-LED5 lighting
•
80-61% ROC: LED1-LED4 lighting
•
60-41% ROC: LED1-LED3 lighting
•
40-21% ROC: LED1-LED2 lighting
•
20-11% ROC: LED1 lighting
•
10-0% ROC: LED1 flashing
During charging
•
100% ROC: LED1-LED5 lighting
•
99-81% ROC: LED1-LED4 lighting
•
80-61% ROC: LED1-LED3 lighting
•
60-41% ROC: LED1-LED3 lighting
•
40-21% ROC: LED1-LED2 lighting
•
20-11% ROC: LED1 lighting
•
10-0% ROC: LED1 flashing