a2b Obree, Руководство пользователя

Страница: 38 / 80

38
Owner’s manual
Extreme example:
an incline of 10-12% at an altitude of
500 metres, a total weight of 120 kg,
loose terrain, a maximum assistance level,
a travelling speed of < 10 km/h and a
cadence of 60 rpm mean operation in an
unfavourable range at low efficiency and
travelling range and, at the same time, high
heat generation. This will lead to a reduction
of the drive power.
Tip:
By selecting a lower gear with higher
cadence, the travel mode "Tour" or "Eco",
a reduced assistance level and/or a short
break (in which the drive can cool down
again), you may ideally continue to cycle.
The motor must never be "forcibly
cooled" from outside by means of water!
This may cause damage and does not
support cooling very much since especially
the inside of the motor
becomes hot.
5.5 Motor
The drive wheel of your Pedelec can be
removed from the bicycle frame at any
time, such as for cleaning or in case of
a puncture. Proceed extremely carefully
when removing and afterwards mounting
the drive wheel and, in particular, observe
the information and instructions of the
manufacturers of the various components
fitted to the wheel, especially the brake
disk. (Note: For better clarity, the following
charts only show the drive motor integrated
in the wheel, but not the complete drive
wheel).
5.5.1 Removal of the drive wheel
Record or remember the cable installation
and the fixing points of the cable ties before
removing the drive wheel. First loosen and
remove all cable ties attaching the cable
[16] coming from the motor and cables and
supply lines of other components to the
bicycle frame. Afterwards, disconnect the
plug [15] on the cable of the motor [16]
from the socket [17] on the battery cable.
Loosen the two nuts [18] or the quick
release used for fixing the wheel to the
frame so that the complete wheel can be
removed from your Pedelec's frame.
Remember or mark the position of the
torque support [20]. It must be reattached
in exactly the same position as before
removal when fitting the wheel later.
Never hold or transport the removed
wheel on the cable [16] coming from the
motor! There is a risk of cable break.