4RF Aprisa SR+, Руководство пользователя

Страница: 70 / 492

70 | Implementing the Network
Aprisa SR+ User Manual 1.11.1
Initial Network Deployment
Install the Base Station
To install the base station in your network:
1. Install the base station radio (see ‘ Installing the Radio ’ on page 80).
2. Set the radio Network ID to a unique ID in your entire network (see ‘ Terminal > Device ’ on page 111).
3. Set the radio operating mode to ‘base station’ (see ‘ Terminal > Operating Mode ’ on page 119).
4. Set the radio IP address (see ‘ IP > IP Setup > Bridge / Gateway Router Modes ’ on page 183).
5. Set the radio frequencies to the frequencies you wish to operate from (see ‘ Radio > Radio Setup ’ on
page 129).
6. Set the radio security settings (see ‘ Security > Setup ’ on page 227).
Installing the Remote radios
To install the remote radios in your network:
1. Install the remote radio (see ‘ Installing the Radio ’ on page 80).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘ Terminal > Device ’
on page 111).
3. If repeater used in radius 1, set the network radius=2 on all network stations (see ‘ Terminal > Device ’
on page 111).
4. Set the radio operating mode to ‘ remote radio ’ (see ‘ Terminal > Operating Mode ’ on page 119).
5. Set the radio IP address (see ‘ IP > IP Setup > Bridge / Gateway Router Modes ’ on page 183).
6. Set the radio frequencies to the base station / repeater station frequencies you wish to operate from
(see ‘ Radio > Radio Setup ’ on page 129).
7. Set the radio security settings to the same as the base station (see ‘ Security > Setup ’ on page 227).
The base station will automatically allocate a node address to the new remote radio.
Install a Repeater Station
To install a repeater station in your network:
1. Install the repeater station radio (see ‘ Installing the Radio ’ on page 80).
2. Set the radio Network ID to the same ID as the other stations in the network (see ‘ Terminal > Device ’
on page 111).
3. Increase the radio network radius by one on all stations in the network (see ‘ Terminal > Device ’ on page
111).
4. Set the radio operating mode to ‘repeater station’ (see ‘ Terminal > Operating Mode ’ on page 119).
5. Set the radio IP address (see ‘ IP > IP Setup > Bridge / Gateway Router Modes ’ on page 183).
6. Set the radio frequencies to base station frequencies you wish to operate from (see ‘ Radio > Radio
Setup ’ on page 129).
7. Set the radio security settings to the same as the base station (see ‘ Security > Setup ’ on page 227).
The base station will automatically allocate a node address to the new repeater station.