24dot
d1 d4 d7
d2 d5
d3 d6
24dot
d70
d71
d72
MSB
LSB
D1=00H, D4=00H, D7=00H, D10=00H ......
D2=1FH, D5=78H, D8=60H, D11=00H ......
D3=C0H, D6=30H, D9=38H, D12=70H ......
FS S n1 n2
[Name] Set left- and right-side Kanji character spacing
[Format] ASCII FS S n1 n2
Hex 1C 53 n1 n2
Decimal 28 83 n1 n2
[Range] 0
≤
n 1
≤
255
0
≤
n 2
≤
255
[Description] Sets left- and right-side Kanji character spacing n1 and n2, respectively.
• When the printer model used supports GS P, the left-side character spacing is [n1
×
horizontal or vertical motion
units], and the right-side character spacing is [ n2
×
horizontal or vertical motion units].
[Details] • When double-width mode is set, the left- and right-side character spacing is twice the normal value.
• The horizontal and vertical motion units are set by
GS P
. The previously specified character spacing does not change,
even if the horizontal or vertical motion unit is changed using
GS P
.
• The value cannot be less than the minimum horizontal movement amount, and must be in even units of the minimum
horizontal movement amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in page mode, depending on starting position of the printable
area as follows:
①
When the starting position is set to the upper left or lower right of the printable area using
ESC T
, the horizontal
Programmer
Manual
Содержание RPT008
Страница 1: ......