3nStar RPT008, Руководство программиста, Страница: 18 / 44

set to (vertical printable area - vertical starting position).
• The horizontal and vertical motion unit are specified by GS P . Changing the horizontal or vertical motion unit does not
affect the current printing area.
• The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement amount, and it must be in even units of
minimum hori-zontal movement amount.
• Use the horizontal motion unit ( x) for setting the horizontal starting position and printing area width, and use the
vertical motion unit ( y) for setting the vertical starting position and printing area height.
• When the horizontal starting position , vertical starting position, printing area width, and printing area height are defined
as X, Y, Dx, and Dy respectively, the printing area is set as shown in the figure below.
•
This printable area for this printer is approximately 72 mm in the horizontal direction and approximately 117.3 mm
(1662/360 inches) in the vertical direction.
[Default] xL = xH = yL = yH = 0
dxL = 0, dxH = 2, dyL = 126, dyH = 6
[Reference] CAN, ESC L, ESC T, GS P
(x, y)
D
y
Dx
Print atea
F
o
rw
a
rd
(x+Dx-1, Dy-1)
ESC \ nL nH
[Name] Set relative print position
[Format] ASCII ESC \ nL nH
Hex 1B 5C nL nH
Decimal 27 92 nL nH
[Range] 0
≤
nL
≤
255
0
≤
nH
≤
255
[Description] • Sets the print starting position based on the current position by using the horizontal or vertical motion unit.
• This command sets the distance from the current position to [( nL + nH×256)×horizontal or vertical motion unit]
[Details] • Any setting that exceeds the printable area is ignored.
• When pitch N is specified to the right:
nL+ nH×256 = N
When pitch N is specified to the left (the negative direction), use the complement of 65536.
When pitch N is specified to the left:
nL+ nH×256 = 65536 - N
• The print starting position moves from the current position to [ N×horizontal or vertical motion unit]
• The horizontal and vertical motion unit are specified by GS P .
• The GS P command can change the horizontal (and vertical) motion unit. However, the value cannot be less than the
minimum horizontal movement amount, and it must be in even units of the minimum horizontal movement amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs as follows, depending on the starting point of the printing area:
①
When the starting position is set to the upper left or lower right of the printable area using ESC T, the horizontal motion
unit ( x) is used.
②
When the starting position is set to the upper right or lower left of the printable area using ESC T, the vertical motion
unit ( y) is used.
[Reference] ESC $, GS P
Programmer Manual