page
31
of
62
3DGence DOUBLE P255 | version 09.2018
2.2.
Starting the printer
1.
To start the printer for the first time (after taking it out of the cardboard box) follow the instructions on "Quickstart" card
placed in the packaging.
2.
Make certain that all the packing elements have been removed.
3.
Place the printer on an even and stable surface and connect it to a power source using a power lead. The power supply
socket is located at the back of the printer (fig. 36).
Fig. 36 Rear view of the printer: 1. Power supply socket | 2. Printer switch
4.
To switch the printer on, press ON/OFF button on the right side of the rear panel (fig. 36). The working field lights will light
up and the printer's display will be switched on. When the printer's main menu is displayed, the printer is ready to start
working.
3. HEATBED PREPARATION
3DGence DOUBLE P255 printer has a ceramic heatbed. Such a solution guarantees good adhesion of the first printout layer and
easy removal of the model after the printing process. After transport, the surface of the printer's heatbed may be contaminated
with traces of grease or dust and should be cleaned. The heatbed cleaning procedure is described in chapter IV, point 4.2.
ATTENTION:
there are OHS instructions on the packaging of the solvents used for cleaning. The instructions must be strictly
observed
–
the solvent vapours may be harmful. Good ventilation must be ensured.
3.1. Heatbed calibration
3DGence DOUBLE P255 printer is equipped with an advanced, extremely sensitive system of automatic calibration of the
heatbed. This system facilitates the printer operation. The correct calibration procedure of the printer's heatbed is described
below. The printer has been calibrated prior to transport, but it may have become decalibrated during transport. Therefore,
the following actions should be performed in order to avoid problems with the first printout.
The heatbed calibration procedure is always the same. There is no need to perform the calibration before each printout. It is
enough to perform it once every few dozen hours of printing or if there are problems with the adhesion of the first layer of
printout.
Содержание DOUBLE
Страница 1: ...USER S MANUAL 3DGence DOUBLE P255 ...
Страница 27: ...page 27 of 62 3DGence DOUBLE P255 version 09 2018 Fig 33 Main menu structure in the idle mode ...
Страница 28: ...page 28 of 62 3DGence DOUBLE P255 version 09 2018 Fig 34 Advanced menu structure ...
Страница 29: ...page 29 of 62 3DGence DOUBLE P255 version 09 2018 Fig 35 Main menu structure in the working mode ...
