page
37
of
62
3DGence DOUBLE P255 | version 09.2018
8.
The extruder motor will start after activation of the filament sensor. Push the filament so that its tip passes through the
entire length of the bowden tube up to the extruder.
9.
When the nominal material extrusion temperature is reached, the process will start automatically.
10.
Observe the nozzle tip carefully. The printer will perform a test-extrusion of a short section of the filament.
11.
Confirm successful loading of material with "
CONTINUE"
key and remove the remaining extruded material from the
heatbed.
12.
The printer will restart the printing process automatically.
4.5.
Depletion of material during printing
The printer's system monitors the condition of the filament sensor on an ongoing basis. If the material is depleted on one of
the spools (T0 or T1), the printing process will be stopped and the module will move to a safe position. Next, the remaining
filament will be unloaded automatically from the bowden tube and the message
"Materiał T0/T1 depleted
" will be displayed.
At this point, the user can load a new material or return to
MATERIALS
menu. In order to load a new filament, choose the
"
CONTINUE
" option. The printer will start the material loading manager (chapter III, point 4.1).
IV FIRST PRINTOUT
1.
STARTING A READY CODE FROM SD CARD
The 3DGence DOUBLE P255 printer is equipped with a SD memory card. The procedure of starting the printing process from
SD card is easy and quick.
Prepared .stl and .gcode models are available at www.3dgence/support in the Your file tab (the tab is available after creating
an account and registering the device).
Before making the first printout confirm that:
•
an appropriate place for the printer operation is provided,
•
the printer is properly connected to the power supply,
•
all axes of the printer move freely,
•
the heatbed is properly calibrated,
•
SD memory card is properly installed in the printer,
•
filaments are properly loaded,
•
all readouts from the printer's sensors are correct.
ATTENTION:
Failure to meet the above conditions and the conditions mentioned before in manual before making the
first printout may cause damage to the printer or injury to the operator. Always follow the safety instructions, even if
you are an experienced operator.
ATTENTION:
Insert SD card into SD card slot with SD card's pins upwards!
Fig. 41 Proper position of SD card in SD card slot
Содержание DOUBLE
Страница 1: ...USER S MANUAL 3DGence DOUBLE P255 ...
Страница 27: ...page 27 of 62 3DGence DOUBLE P255 version 09 2018 Fig 33 Main menu structure in the idle mode ...
Страница 28: ...page 28 of 62 3DGence DOUBLE P255 version 09 2018 Fig 34 Advanced menu structure ...
Страница 29: ...page 29 of 62 3DGence DOUBLE P255 version 09 2018 Fig 35 Main menu structure in the working mode ...
