page
57
of
62
3DGence DOUBLE P255 | version 09.2018
IX ENCLOSURE ASSEMBLY
WARNING:
Printer has to be placed on a firm, level surface at least 630×630 mm big.
1.
If the materials are loaded
–
turn the printer on and unload them by choosing:
MATERIALS → UNLOAD MODEL
MATERIAL/UNLOAD SUPPORT MATERIAL
and follow the steps on the screen.
WARNING:
in case of problems with material unloading, refer to user's manual (chapter III, point 4.3).
2.
Turn the printer off.
3.
Pull out the bowden tubes from both extruders (fig. 67). To do that:
•
remove the collet clip (fig. 67, step 1),
•
push and hold the protective ring down (fig. 67, step 2), at the same time pull out the bowden tube (fig. 67, step 3).
Fig. 67 Pulling out the bowden tubes from both extruders
4.
Mount the rear enclosure part (fig. 68). Align the curvature of the enclosure, so that it interlocks with the back of the
printer (fig. 68).
Fig. 68 Mounting the rear enclosure part
5.
Mount the clips on the rear enclosure part. The side of the magnetic clips should fit into the recess on the printer (fig. 69).
Fig. 69 Mounting the clips on the rear enclosure part
Содержание DOUBLE
Страница 1: ...USER S MANUAL 3DGence DOUBLE P255 ...
Страница 27: ...page 27 of 62 3DGence DOUBLE P255 version 09 2018 Fig 33 Main menu structure in the idle mode ...
Страница 28: ...page 28 of 62 3DGence DOUBLE P255 version 09 2018 Fig 34 Advanced menu structure ...
Страница 29: ...page 29 of 62 3DGence DOUBLE P255 version 09 2018 Fig 35 Main menu structure in the working mode ...
