3D Nord QMS 1060, Начало работы

Страница: 51 / 110

Using the
LocalTalk
Interface
3-5 Connecting to a Macintosh
Making the Connection
Use the following procedure to connect your printer to the Macintosh.
▲
Caution
: Turn off both the printer and the Macintosh before making
the connection.
1 Plug the connector from one transformer box into the
printer’s LocalTalk port.
2 Plug the connector from the other transformer box into the
Macintosh printer port.
3 Connect the two transformer boxes with the telephone cable.
4 Put terminating resistors in all open sockets in the connec-
tor boxes.
This ensures proper communication and helps speed up trans-
mission.
5 Turn on the printer.
A start-up page should print if it has not been disabled.
Macintosh Printing Software
If your Macintosh was previously connected to a PostScript printer,
you can probably start printing now with the printing software already
in place. Refer to your application documentation for instructions on
sending a document to the printer.
However, if you want to use all of your printer's special features (like
collation, 600x600 dpi printing, and gamma correction), or if you've
never printed to a PostScript printer before, you need to take a few
minutes to make sure you have the following printing software
installed:
n
PS Executive Series Utilities
n
The 1060 PPD file
n
Application-specific printer files
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500