3Com V6100, Руководство пользователя, Страница: 221 / 496

V6100 and V7122 User Guide
221
ini File Field Name
Web Parameter Name
Valid Range and Description
AltRoutingTel2IPMode
[Alt Routing Tel to IP Mode]
0 (None) = Alternative routing is not used.
1 (Conn) = Alternative routing is performed if ping to initial destination failed.
2 (QoS) = Alternative routing is performed if poor quality of service was
detected.
3 (All) = Alternative routing is performed if, either ping to initial destination
failed, or poor quality of service was detected, or DNS host name is not
resolved (default).
QoS is quantified according to delay and packet loss, calculated
according to previous calls. QoS statistics are reset if no new
data is received for two minutes.
For information on the Alternative Routing feature, see
Fax &
Modem Transport Modes .
IPConnQoSMaxAllowedPL
[ Max Allowed Packet Loss
for Alt Routing ]
Packet loss percentage at which the IP connection is considered a failure.
The range is 1% to 20%. The default value is 20%.
IPConnQoSMaxAllowedDe
lay
[Max Allowed Delay for Alt
Routing]
Transmission delay (in msec) at which the IP connection is considered a
failure.
The range is 100 to 1000. The default value is 250 msec.
E1/T1 Configuration Parameters
Table 52 E1/T1/J1 Configuration Parameters
ini File Field Name
Web Parameter Name
Valid Range and Description
TDMBusType TP-260 only.
Must be set to 2.
PCMLawSelect
[PCM Law Select]
1 = A-law
3 =
μ
-Law
Usually A-Law is used for E1 spans and
μ
-Law for T1 and J1 spans.