3Com Router 3031, Справочник по командам

Страница: 386 / 838

386 C
HAPTER
4: L
INK
L
AYER
P
ROTOCOL
Description
Using the x25 switch svc xot command, you can add an X.25 switching route
whose forwarding address is XOT channel. Using the undo x25 switch svc xot
command, you can delete the specified X.25 switching route.
By default, no X.25 switching route is configured.
After configuring the XOT switching command of X.25 SVC, a user can cross IP
network from the local X.25 network to implement the interconnection with the
remote X.25 network. If a user configures the keepalive attribute, the link
detection for XOT will be supported.
Table 24 XOT channel parameter option
For the related commands, see x25 switch svc interface , display
x25 switch-table svc , and x25 switching .
Example
Switch SVC 1 to the destination address 10.1.1.1.
[3Com] x25 switch svc 1 xot 10.1.1.1
x25 switching Syntax
x25 switching
undo x25 switching
View
System view
Parameter
None
Description
Using the x25 switching command, you can enable the X.25 switching function.
Using the undo x25 switching command, you can disable this function, which will
not affect the established VC switching function.
By default, X.25 packet switching function is disabled.
X.25 packet switching is used to accept packets from an X.25 interface and send
them to a certain interface based on the destination information contained in the
packets. The Router can be used as a small-sized packet switch by the packet layer
switching function.
Option Explanation
timer seconds Keepalive timer delay of XOT connection. The timer sends the keepa
detect the connection availability. Its value ranges from 1 to 3600.
retry times Number of maximum retries of sending keepalive. If the number exc
connection will be disconnected. Its value ranges from 3 to 3600.
source interface-type interface-name Interface name of initiating XOT connection