2N Access Unit, Руководство по настройке

Страница: 106 / 134

2N Access Unit Configuration Manual
106 / 134
•
•
•
•
•
VLAN ID – select a virtual network ID in the range of 1-4094. The device shall receive only
the packets tagged with this ID. A wrong setting may result in a connection loss and need
to reset the device to factory values.
Required Port Mode – set the preferred network interface port mode: Autonegotiation or
Half Duplex – 10 mbps. The lower bit rate of 10 mbps may be necessary if the used network
infrastructure (cabling) is not reliable for the 100mbps traffic.
Current Port State – current network interface port state (Half or Full Duplex – 10 mbps or
100 mbps).
Verify the network address accessibility – verify the network address accessibility via
the Ping command in standard operating systems. Press Ping to display a dialogue, enter
the IP address/domain name and click Ping to send test data to this address. If the
selected IP address/domain name is invalid, a warning is displayed and Ping remains
inactive until the given IP address becomes valid.
The function progress and result are also displayed in the dialogue. Failed means either
inaccessibility of the given IP address within 10 seconds or inability to translate the
domain name into an address. If a valid response is received, the IP address from which
the response came and the response waiting time in milliseconds are displayed.
Repress Ping to send another query to the same address.
802.1x
The tab is not displayed for 2N Access Unit 2.0, which does not support the 802.1x protocol.
Device Identity – set the user name (identity) for authentication via EAP-MD5 and EAP-
TLS.