2N Access Unit, Руководство по настройке

Страница: 38 / 134

2N Access Unit Configuration Manual
38 / 134
•
•
•
•
•
Switch Enabled – enable/disable the switch globally. When disabled, the switch cannot
be activated by any of the available codes (including user switch codes), by quick dial
button.
Switch mode – set the monostable/bistable mode for the switch. The switch is switched
off after a timeout in the monostable mode and switched on with the first activation and
off with the next activation in the bistable mode.
Switch-on duration – set the switch-on time for a monostable switch. This value is not
applied in the bistable mode.
Controlled output – assign an electric output to the switch. Choose one of the available
intercom outputs: relay, power output, extender output. If you select None , the switch will
not control any electric output but can control external equipment via HTTP commands.
Output type – if you use the 2N
®
IP Intercom - Security Relay module, set the output
type to Security . In the Security mode, the output works in the inverse mode, i.e. remains
closed and controls the 2N
®
IP Intercom - Security Relay module using a specific pulse
sequence. If you use the inverse mode (i.e. the door is locked when voltage is applied), set
the
inverse output type. In case multiple switches are set to the same output but different
output types, the following priority will be applied: 1. security, 2. inverse, 3. normal.
•
Info
A switch activation value higher than 1 s can be set for the security output type. A
value equal to or higher than 0.1 s can be set for the normal and inverse output
types.
