ZyXEL Communications WX3401-BO, User Manual

Page: 115 / 180

Chapter 7 Home Networking
WX3401-B0 User’s Guide
115
7.2 Home Networking Screen
Use this screen to set the IP address and subnet mask of your WX3401-B0. Configure DHCP settings to
have a DHCP server assign IP addresses to devices. Click
Network Setting > Home Networking to open
the Home Networking screen.
Follow these steps to configure your LAN settings.
1
Enter an IP address into the IP Address field. The IP address must be in dotted decimal notation. This will
become the IP address of your WX3401-B0.
2
Enter the IP subnet mask into the IP Subnet Mask field. Unless instructed otherwise it is best to leave this
alone, the configurator will automatically compute a subnet mask based upon the IP address you
entered.
3
Click Apply to save your settings.
Figure 57 Network Setting > Home Networking > Home Networking
The following table describes the fields in this screen.
Table 24 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
LAN IP Setup
Select DHCP to deploy the WX3401-B0 as a DHCP client in the network. When you enable this,
the WX3401-B0 gets its IP address from the network’s DHCP server (for example, your ISP or
router). Users connected to the WX3401-B0 can now access the network (i.e., the Internet if the
IP address is given by the ISP or a router with Internet access). When you select this, you cannot
enter an IP address for your WX3401-B0 in the field below.
Select
Static IP if you want to specify the IP address of your WX3401-B0. Or if your ISP or network
administrator gave you a static IP address to access the network or the Internet.
IP Address Enter the LAN IPv4 IP address you want to assign to your WX3401-B0 in dotted decimal notation,
for example, 192.168.1.2 (factory default).