ZyXEL Communications VMG1312-T10C, User Manual

Page: 67 / 238

Chapter 6 Wireless
VMG1312-T10C User’s Guide
67
6.5 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your Device.
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Set up each WPS connection between two devices. Both
devices must support WPS. See
Section 6.10.7.3 on page 80 for more information about WPS.
Note: The Device applies the security settings of the SSID1 profile (see Section 6.2 on
page 57 ). If you want to use the WPS feature, make sure you have set the security
mode of SSID1 to WPA2-PSK or WPA-PSK/WPA2-PSK mixed or no security.
Add new MAC
address Click this if you want to add a new MAC address entry to the MAC filter list below.
Enter the MAC addresses of the wireless devices that are allowed or denied access to the
Device in these address fields. Enter the MAC addresses in a valid MAC address format, that
is, six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.
Figure 34
Wireless > MAC Authentication > Add new MAC address
# This is the index number of the entry.
MAC Address This is the MAC addresses of the wireless devices that are allowed or denied access to the
Device.
Modify Click the Delete icon to delete the entry.
Apply Click Apply to save your changes.
Cancel Click Cancel to exit this screen without saving.
Table 16
Wireless > MAC Authentication (continued)
LABEL DESCRIPTION