ZyXEL Communications USG-300 - V2.20 ED 2, Manual

Page: 498 / 1149

Chapter 25 IPSec VPN
ZyWALL USG 300 User’s Guide
498
NAT Traversal Select this if any of these conditions are satisfied.
• This IKE SA might be used to negotiate IPSec SAs that use ESP as
the active protocol.
• There are one or more NAT routers between the ZyWALL and
remote IPSec router, and these routers do not support IPSec
pass-thru or a similar feature.
The remote IPSec router must also enable NAT traversal, and the
NAT routers have to forward packets with UDP port 500 and UDP
4500 headers unchanged.
Dead Peer
Detection
(DPD)
Select this check box if you want the ZyWALL to make sure the
remote IPSec router is there before it transmits data through the IKE
SA. The remote IPSec router must support DPD. If there has been no
traffic for at least 15 seconds, the ZyWALL sends a message to the
remote IPSec router. If the remote IPSec router responds, the
ZyWALL transmits the data. If the remote IPSec router does not
respond, the ZyWALL shuts down the IKE SA.
If the remote IPSec router does not support DPD, see if you can use
the VPN connection connectivity check (see
Section 25.2.1 on page
480 ).
More Settings/
Less Settings Click this button to show or hide the Extended Authentication
fields.
Extended
Authentication When multiple IPSec routers use the same VPN tunnel to connect to
a single VPN tunnel (telecommuters sharing a tunnel for example),
use extended authentication to enforce a user name and password
check. This way even though they all know the VPN tunnel’s security
settings, each still has to provide a unique user name and password.
Enable Extended
Authentication Select this if one of the routers (the ZyWALL or the remote IPSec
router) verifies a user name and password from the other router
using the local user database and/or an external server.
Server Mode Select this if the ZyWALL authenticates the user name and password
from the remote IPSec router. You also have to select the
authentication method, which specifies how the ZyWALL
authenticates this information.
Client Mode Select this radio button if the ZyWALL provides a username and
password to the remote IPSec router for authentication. You also
have to provide the
User Name and the Password .
User Name This field is required if the ZyWALL is in Client Mode for extended
authentication. Type the user name the ZyWALL sends to the remote
IPSec router. The user name can be 1-31 ASCII characters. It is
case-sensitive, but spaces are not allowed.
Password This field is required if the ZyWALL is in Client Mode for extended
authentication. Type the password the ZyWALL sends to the remote
IPSec router. The password can be 1-31 ASCII characters. It is case-
sensitive, but spaces are not allowed.
OK Click OK to save your settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
Table 131 Configuration > VPN > IPSec VPN > VPN Gateway > Edit (continued)
LABEL DESCRIPTION