ZyXEL Communications USG-300 - V2.20 ED 2, Manual

Page: 362 / 1149

Chapter 13 Interfaces
ZyWALL USG 300 User’s Guide
362
13.11 Virtual Interfaces
Use virtual interfaces to tell the ZyWALL where to route packets. Virtual interfaces
can also be used in VPN gateways (see
Chapter 25 on page 475 ) and VRRP groups
(see Chapter 39 on page 709 ).
Virtual interfaces can be created on top of Ethernet interfaces, VLAN interfaces, or
bridge interfaces. Virtual VLAN interfaces recognize and use the same VLAN ID.
Otherwise, there is no difference between each type of virtual interface. Network
policies (for example, firewall rules) that apply to the underlying interface
automatically apply to the virtual interface as well.
Like other interfaces, virtual interfaces have an IP address, subnet mask, and
gateway used to make routing decisions. However, you have to manually specify
the IP address and subnet mask; virtual interfaces cannot be DHCP clients. Like
other interfaces, you can restrict bandwidth through virtual interfaces, but you
Phone Number Enter the phone number to dial here. You can use 1-20 numbers,
commas (,), or plus signs (+). Use a comma to pause during dialing.
Use a plus sign to tell the external modem to make an international
call.
User Name Enter the user name required for authentication.
Password Enter the password required for authentication.
Retype to
confirm
Enter the password again to make sure you have not typed it
incorrectly.
Authentication
Type
Select the authentication protocol to use for outgoing calls. Choices
are:
CHAP/PAP - Your ZyWALL accepts either CHAP (Challenge
Handshake Authentication Protocol) or PAP (Password Authentication
Protocol), as requested by the computer you are dialing.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
Timeout Type the number of seconds the ZyWALL tries to set up a connection
before it stops. Allowed values are 30 - 120.
Idle timeout Type the number of seconds the ZyWALL should wait for traffic before
it automatically disconnects the connection. Set this field to zero to
disable the idle timeout. Allowed values are 0 - 360.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 83 Configuration > Network > Interface > Auxiliary (continued)
LABEL DESCRIPTION