Prestige 650HW ADSL Router
Remote Node Configuration
4-7
4.2 Remote
Node
Setup
For the TCP/IP parameters, perform the following steps to edit
Menu 11.3 – Remote Node Network
Layer Options
as shown next.
Step 1.
In menu 11.1, make sure
IP
is among the protocols in the
Route
field.
Step 2.
Move the cursor to the
Edit IP/Bridge
field, press [
SPACE BAR
] to select
Yes,
then press
[ENTER]
to display
Menu 11.3
–
Remote Node Network Layer Options.
Figure 4-3 Remote Node Network Layer Options
The next table explains fields in
Menu 11.3
–
Remote Node Network Layer Options
.
Table 4-2 Remote Node Network Layer Options
FIELD DESCRIPTITON
EXAMPLE
IP Address
Assignment
Press [SPACE BAR] and then [ENTER] to select
Dynamic
if the remote
node is using a dynamically assigned IP address or
Static
if it is using a
static (fixed) IP address. You will only be able to configure this in the
ISP node (also the one you configure in menu 4), all other nodes are
set to
Static
.
Static
Rem IP Addr
This is the IP address you entered in the previous menu.
Rem Subnet
Mask
Type the subnet mask assigned to the remote node.
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment= Static Ethernet Addr Timeout (min)= 0
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set= 2
Metric= 2
Private= No
RIP Direction= None
Version= None
Multicast= None
IP Policies= 3,4,5,6
Press ENTER to Confirm or ESC to Cancel:
Rem Node Name= myISP
Route= IP