Prestige 650HW ADSL Router
IP Policy Routing
13-5
Table 13-2 IP Routing Policy
FIELD DESCRIPTION
Len Comp
Press [SPACE BAR] and then [ENTER] to choose from
Equal
,
Not Equal
,
Less
,
Greater
,
Less
or
Equal
or
Greater
or
Equal
.
Source:
addr start / end Source IP address range from start to end.
port start / end Source port number range from start to end; applicable only for TCP/UDP.
Destination:
addr start / end Destination IP address range from start to end.
port start / end Destination port number range from start to end; applicable only for TCP/UDP.
Action
Specifies whether action should be taken on criteria
Matched
or
Not
Matched
.
Gateway addr
Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it is on the LAN, otherwise, the gateway must be the
IP address of a remote node. The default gateway is specified as 0.0.0.0.
Type of Service
Set the new TOS value of the outgoing packet. Prioritize incoming network
traffic by choosing
No Change
,
Normal
,
Min Delay
,
Max Thruput
,
Max
Reliable
or
Min Cost
.
Precedence
Set the new outgoing packet precedence value. Values are
0
to
7
or
No
Change
.
Log
Press [SPACE BAR] and then [ENTER] to select
Yes
to make an entry in the
system log when a policy is executed.
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
13.5 Applying an IP Policy
This section shows you where to apply the IP policies after you design them.
13.5.1 Ethernet IP Policies
From
Menu 3
—
Ethernet Setup
, type 2 to go to
Menu 3.2
—
TCP/IP and DHCP Ethernet Setup
.