ZyXEL Communications P-861H-G1, User Manual, Page: 234 / 341

Prestige 861H Series User’s Guide
233 Chapter 26 Remote Management
Figure 158 Menu 24.11 Remote Management Control
Menu 24.11 - Remote Management Control
TELNET Server:
Server Port = 23 Server Access = ALL
Secured Client IP = 0.0.0.0
FTP Server:
Server Port = 21 Server Access = ALL
Secured Client IP = 0.0.0.0
Web Server:
Server Port = 80 Server Access = ALL
Secured Client IP = 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.
Table 71 Menu 24.11 Remote Management Control
FIELD DESCRIPTION
Telnet Server
FTP Server
Web Server
Each of these read-only labels denotes a service or protocol.
Port This field shows the port number for the service or protocol. You may change the
port number if needed, but you must use the same port number to access the
Prestige.
Access Select the access interface (if any) by pressing the [SPACE BAR]. Choices are:
LAN only , WAN only , All or Disable . The default is LAN only .
Secured Client IP The default 0.0.0.0 allows any client to use this service or protocol to access the
Prestige. Enter an IP address to restrict access to a client with a matching IP
address.
When you have completed this menu, press [ENTER] at the prompt “ Press ENTER to Confirm
or ESC to Cancel: ” to save your configuration, or press [ESC] at any time to cancel.
26.2.2 Remote Management Limitations
Remote management over LAN or WAN will not work when:
• A filter in menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or
Web service.
• You have disabled that service in menu 24.11.
• The IP address in the
Secured Client IP field (menu 24.11) does not match the client IP
address. If it does not match, the Prestige will disconnect the session immediately.
• There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
• There is a firewall rule that blocks it.