ZyXEL Communications P-861H-G1, User Manual, Page: 205 / 341

Prestige 861H Series User’s Guide
Chapter 22 SNMP Configuration 204
Figure 136 Menu 22 SNMP Configuration
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
The following table describes the SNMP configuration parameters.
Table 60 Menu 22 SNMP Configuration
FIELD DESCRIPTION
SNMP:
Get Community Type the Get Community , which is the password for the incoming Get- and
GetNext requests from the management station.
Set Community Type the Set community, which is the password for incoming Set requests from
the management station.
Trusted Host If you enter a trusted host, your Prestige will only respond to SNMP messages
from this address. A blank (default) field means your Prestige will respond to all
SNMP messages it receives, regardless of source.
Trap:
Community Type the trap community, which is the password sent with each trap to the
SNMP manager.
Destination Type the IP address of the station to send your SNMP traps to.
When you have completed this menu, press [ENTER] at the prompt “ Press ENTER to Confirm
or ESC to Cancel: ” to save your configuration, or press [ESC] at any time to cancel.
22.4 SNMP Traps
The Prestige will send traps to the SNMP manager when any one of the following events
occurs:
Table 61 SNMP Traps
TRAP # TRAP NAME DESCRIPTION
1 coldStart ( defined in RFC-1215 ) A trap is sent after booting (power on).
2 warmStart ( defined in RFC-1215 ) A trap is sent after booting (software reboot).
3 linkDown ( defined in RFC-1215 ) A trap is sent with the port number when any of the
links are down. See the following table.
4 linkUp ( defined in RFC-1215 ) A trap is sent with the port number.