ZyXEL Communications P-2612HW-F1 -, User Manual

Page: 222 / 547

Chapter 11 Phone Usage
P-2612HW Series User’s Guide
222
1
During the call, press “*97#” and then any number (up to 8 digits long). You need
to remember this number in order to pick up the call on another phone. Hang up
the receiver.
2
Pick up another phone’s receiver. Press “#97#” followed by the same number you
entered before to continue the call.
11.5 Checking the ZyXEL Device’s IP Address
Do the following to listen to the ZyXEL Device’s current IP address.
1
Pick up your phone’s receiver.
2
Press “****” on your phone’s keypad and wait for the message that says you are
in the configuration menu.
3
Press “5” followed by the # key.
4
Listen to the IP address and make a note of it.
5
Hang up the receiver.
11.6 Auto Provisioning and Auto Firmware
Upgrade
If your service provider uses an auto-provisioning server to set up your device,
you must first enter the HTTP pincode (supplied by your service provider). This
authenticates your ZyXEL Device with the auto provisioning server, allowing you to
use the service.
• On a phone connected to the device, enter “*99**”, your SIP number, “*”, the
HTTP pincode you were given, then “#”.
• For example, if your SIP number is 0123456 and the HTTP pincode you were
given is 9876, you would enter “*99**0123456*9876#”.
During auto-provisioning, the ZyXEL Device checks to see if there is a newer
firmware version (if your service provider activates this feature). If newer
firmware is available, the ZyXEL Device plays a recording when you pick up your
phone’s handset.
• Press “*99#” to upgrade the ZyXEL Device’s firmware.
• Press “#99#” to not upgrade the ZyXEL Device’s firmware.