Chapter 17 Link Aggregation
XMG1930 Series User’s Guide
173
Figure 122
Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 79 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
DESCRIPTION
Link
Aggregation
Control
Protocol
Note: Do NOT configure this screen unless you want to enable dynamic link
aggregation.
Active
Select this check box to enable Link Aggregation Control Protocol (LACP).
System Priority
LACP system priority is a number between 1 and 65535. The switch with the lowest system priority
(and lowest port number if system priority is the same) becomes the LACP “server”. The LACP
“server” controls the operation of LACP setup. Enter a number to set the priority of an active port
using Link Aggregation Control Protocol (LACP). The smaller the number, the higher the priority
level.
Group ID
The field identifies the link aggregation group, that is, one logical link containing multiple ports.
LACP Active
Select this option to enable LACP for a trunk.
Port
This field displays the port number.
