Chapter 9 Wireless LAN
EMG3425-Q10A User’s Guide
81
9.5 MAC Filter Screen
The MAC filter screen allows you to configure the EMG3425-Q10A to give exclusive access to
devices (
Allow
) or exclude devices from accessing the EMG3425-Q10A (
Deny
). Every Ethernet
device has a unique MAC (Media Access Control) address. The MAC address is assigned at the
factory and consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You
need to know the MAC address of the devices to configure this screen.
To change your EMG3425-Q10A’s MAC filter settings, click
Network
>
Wireless LAN 2.4G/5G
>
MAC Filter
. The screen appears as shown.
Intra-BSS Traffic A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled,
wireless clients can access the wired network and communicate with each other. When
Intra-BSS is disabled, wireless clients can still access the wired network but cannot
communicate with each other.
WMM QoS
Check this to have the EMG3425-Q10A automatically give a service a priority level
according to the ToS value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Enable Guest
WLAN
Select the check box to activate guest wireless LAN. This is available only for the last SSID
on the EMG3425-Q10A.
IP Address
Type an IP address for the devices on the Guest WLAN using this as the gateway IP
address.
IP Subnet
Mask
Type the subnet mask for the guest wireless LAN.
Enable
Bandwidth
Management
for Guest
WLAN
Select this to turn on bandwidth management for the Guest WLAN network.
Maximum
Bandwidth
Enter a number to specify maximum bandwidth the Guest WLAN network can use.
Security Mode
Select
Static WEP
,
WPA-PSK
,
WPA
,
WPA2-PSK
or
WPA2
to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as this device. After you select to use a security, additional
options appears in this screen. See
for detailed information on
different security modes. Or you can select
No Security
to allow any client to associate
this network without authentication.
Note: If the WPS function is enabled (default), only
No Security
and
WPA2-PSK
are
available in this field.
Apply
Click
Apply
to save your changes back to the EMG3425-Q10A.
Cancel
Click
Cancel
to reload the previous configuration for this screen.
Table 24
Network > Wireless LAN 2.4G/5G > More AP: Edit (continued)
LABEL
DESCRIPTION
Summary of Contents for EMG3425-Q10A
