ZyXEL Communications AAM1212, User Manual

Page: 82 / 288

AAM1212 User’s Guide
Chapter 7 Basic Setting Screens 81
Figure 42 ENET Port Setup
The following table describes the fields in this screen.
Table 13 ENET Port Setup
LABEL DESCRIPTION
Port This is the port index number.
Active Select this check box to enable a port. The factory default for all ports is enabled. A
port must be enabled for data transmission to occur.
Name Enter a descriptive name that identifies this port. You can use up to 31 ASCII
characters; spaces are not allowed.
Speed Mode Select the type of Ethernet connection for this port. When you don’t use auto-
negotiation, you must make sure that the settings of the peer Ethernet port are the
same in order to connect.
Select
Auto (auto-negotiation) to have the AAM automatically determine the type
of connection that the Ethernet port has. When the peer Ethernet device has auto-
negotiation turned on, the AAM negotiates with the peer to determine the
connection speed. If the peer Ethernet port does not have auto-negotiation turned
on, the AAM determines the connection speed by detecting the signal on the cable
and using full duplex.
Select
10 Copper if the Ethernet port has a 10 MB electrical connection.
Select 100 Copper if the Ethernet port has a 100 MB electrical connection.
Duplex The AAM uses full duplex Ethernet connections.
Apply Click Apply to save your changes to the AAM’s volatile memory. The AAM loses
these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring the fields again.