ZyXEL Communications AAM1212, User Manual

Page: 274 / 288

AAM1212 User’s Guide
Chapter 33 Troubleshooting 273
33.13.1 Resetting the Defaults Via CLI Command
If you know the password, you can reload the factory-default configuration file via Command
Line Interface (CLI) command. Use the following procedure.
1 Connect to the console port using a computer with terminal emulation software. See the
chapter on hardware connections for details.
2 Enter your password.
3 Type
config restore
.
4 Type
y
at the question “
Do you want to proceed(y/n)?
”
5 The AAM restarts.
Figure 170 Resetting the AAM Via Command
The AAM is now reinitialized with a default configuration file including the default password
of “1234”.
33.13.2 Resetting the Defaults Via Boot Commands
If you forget your password or cannot access the AAM, you will need to use this section to
reload the factory-default configuration file. Uploading the factory-default configuration file
replaces the current configuration file with the factory-default configuration file. This means
that you will lose all previous configurations and the speed of the console port will be reset to
the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The
password will also be reset to “1234” and the IP address to 192.168.1.1.
Note: Uploading the factory default configuration file erases the AAM’s entire
configuration.
Obtain the default configuration file, unzip it and save it in a folder. Use a console cable to
connect a computer with terminal emulation software to the AAM’s console port. Turn the
IES-1000 off and then on to begin a session. When you turn on the IES-1000 again you will
see the initial screen. When you see the message
Press any key to enter Debug Mode
within 3 seconds
press any key to enter debug mode.
To upload the configuration file, do the following:
1 Type
atlc
after the
Enter Debug Mode
message.
ras> config restore
System will reboot automatically after restoring default
configuration.
Do you want to proceed(y/n)? >
restoring configuration...
saving configuration to flash...