ZyXEL Communications AAM1212, User Manual

Page: 222 / 288

AAM1212 User’s Guide
Chapter 28 Switch Commands 221
where
This command sets an ADSL port(s) to use an IGMP filter profile.
The following example sets ADSL port 9 to use the voice IGMP filter profile.
Figure 126 IGMP Filter Set Command Example
28.2.3 IGMP Filter Profile Set Command
Syntax:
switch igmpfilter profile set <name> <index> <startip> <endip>
where
This command configures an IGMP filter profile.
The following example configures an IGMP filter profile named voice with a range of
multicast IP addresses (index 1) from 224.1.1.10 to 224.1.1.44.
[<port>|*]
= You can specify a single ADSL port <1> or all ADSL ports
<*>.
<name>
= The name of an IGMP filter profile.
ras> switch igmpfilter set 9 voice
<name>
= Specify a name to identify the IGMP filter profile (you cannot
change the name of the DEFVAL profile). You can use up to 31
ASCII characters; spaces are not allowed.
<index>
= The number (1~16) to identify a multicast IP address range.
<startip>
Type the starting multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile.
<endip>
Type the ending multicast IP address for a range of IP addresses
that you want to belong to the IGMP filter profile.
If you want to add a single multicast IP address, enter it as both
the
startip
and
endip
.