ZyXEL Communications AAM1212, User Manual

Page: 105 / 288

AAM1212 User’s Guide
104 Chapter 8 ADSL Port Setup
8.16 Line Rate Information
Click Basic Setting and then Line Data in the navigation panel to open the following screen.
This screen displays an ADSL port's line operating values. Information obtained prior to
training to steady state transition will not be valid or will be old information.
Figure 52 Line Rate Information
Index This is the number of the IGMP filter profile. Click a profile’s index number to edit
the profile. You cannot edit the DEFVAL profile.
Name This name identifies the IGMP filter profile.
Delete Select the Delete check box and click Delete to remove an IGMP filter profile. You
cannot delete the DEFVAL profile.
Name Type a name to identify the IGMP filter profile (you cannot change the name of the
DEFVAL profile). You can use up to 31 ASCII characters; spaces are not allowed.
Start IP Enter the starting multicast IP address for a range of multicast IP addresses to
which you want this IGMP filter profile to allow access.
End IP Enter the ending multicast IP address for a range of IP addresses to which you
want this IGMP filter profile to allow access.If you want to add a single multicast IP
address, enter it in both the Start IP and End IP fields.
Add Click Add to save your changes to the AAM’s volatile memory. The AAM loses
these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to start configuring the screen again.
Table 21 IGMP Filter Profile (continued)
LABEL DESCRIPTION