Zultys MX250, Hardware Manual

Page: 38 / 62

34
MX250 Hardware Manual
2. Connect all subscriber stations.
•
If you have IP phones or devices enabled with softphones, connect a LAN switch to an
Ethernet port, then connect the IP phones or devices with softphones to the switch.
•
Connect analog telephones, fax machines, or modems through the FXS ports (item 5 of
figure 3-2) or ports on the FXS interface card.
3. Connect voice lines to the PSTN.
•
Connect T1 or E1 circuits through the PCM card’s RJ45 connectors. Configure circuit type
and protocol for each circuit using the MX Administrator software.
•
If you have analog PSTN lines, use the telco connector on the FXO interface card. Figure
6-3 shows the several options in which you can connect to the PSTN using this connector.
4. Connect data lines to the IP WAN.
•
Connect the MX250 to T1 or E1 circuits through the RJ45 ports on the PCM card.
Configure circuit type and protocol for each circuit using the MX Administrator software.
Figure 6-3 Wiring options for FXO on MX250