Zte ZXA10 C300, Configuration Manual

Page: 286 / 301

ZXA10 C300 Configuration Manual (CLI)
ZXAN(config-clock)#show clock config
interface type priority ssm mode status remarks
......................................................................
1/21/1 syncE 1 qlsec - primary source
1/20/1 external 2 qlsec - - source
1/20/3 external 253 qlsec bits - output
clock source count: 2;
wtr 5 minutes ; holdofftime 300 ms; QL-enable
external-clock: unbalance
– End of Steps –
19.4 Configuring PTP Slave Clock
The ZXA10 C300 works as the PTP slave clock to transmit PTP clock signals to downlink
ONU s.
Prerequisite
A reliable PTP source clock exits in the network.
Configuration Data
Table 19-4 lists configuration data of the PTP slave clock configuration.
Table 19-4 PTP Slave Clock Configuration Data
Item Data
PTP slave IP address: 192.168.2.11
Packet type: unicast
Step mode: one-step
Delay request interval: -4
PTP source IP address: 192.168.2.1
PTP VLAN ID 100
ONU interface gpon-onu_1/5/1:1
Steps
1. In PTP configuration mode, configure the PTP slave clock.
ZXAN(config)#ptp
ZXAN(config-ptp)#ptp slave ip 192.168.2.11 packet-type unicast step-mode one-
step interval -4
2. Configure the PTP source.
ZXAN(config-ptp)#ptp-source ip 192.168.2.1
19-6
SJ-20130520164529-007|2013-06-30 (R1.0) ZTE Proprietary and Confidential