Zte ZXA10 C300, Configuration Manual

Page: 15 / 301

Chapter 1 Basic Configuration
1.2 NM Configuration
The ZXA10 C300 supports in-band NM and out-of-band NM.
l In in-band NM mode, the ZXA10 C300 accesses the IP network via the service channel
(uplink port) to transmit NM information. The in-band NM mode is usually used in
practical engineering.
l
In out-of-band NM mode, the ZXA10 C300 accesses the NMS via the 10/100M port
on the switching and control card. The non-service channel is used to transmit the
management information so that the management channel and service channel are
separated. The out-of-band NM mode is usually used in local management and main-
tenance.
1.2.1 Configuring the In-Band NM
In in-band NM mode, the NM information is transmitted via the service channel of the
equipment. The in-band NM mode supports flexible networking and requires no additional
equipment.
Prerequisite
Before this operation, make sure that:
l You have logged in to the ZXA10 C300 through HyperTerminal and entered
administrator mode.
l
The uplink card has been added. (Refer to 1.3.3 Adding a Card .)
Configuration Data
Table 1-1 lists the configuration data of the in-band NM.
Table 1-1 Configuration Data of the In-Band NM
Item Data
Uplink port gei_1/21/1
In-band NM VLAN VLAN ID: 1000
In-band NM IP address 10.1.1.1/24
Next hop IP address 10.1.1.254/24
NM server (SNMP server) IP address: 10.2.1.1/24
Version: V2C
Community name: public
Alarm level: notifications
UDP port: 162
Steps
1. Enter global configuration mode.
ZXAN#configure terminal
1-5
SJ-20130520164529-007|2013-06-30 (R1.0) ZTE Proprietary and Confidential