ZOLL Propaq MD, Operator'S Manual

Page: 67 / 326

Configuring the Waveform Display
9650-0806-01 Rev. D Propaq MD Operator’s Guide 3-7
Configuring the Waveform Display
You can display up to four waveform traces on the Waveform Display window. The first
waveform trace always uses an ECG lead as its source (such as
Pads or Leads l , ll , or lll , and so
on. The default is Pads ). If Pads are not connected, the unit can be configured to
automatically default to another ECG lead for the first trace. As you insert the remaining three
traces, you can specify that the traces use an ECG lead as the waveform source, or that the trace
derive its waveform from other available monitoring functions (such as
Resp
,
CO2
,
SpO2
or
IBP channels P1 , P2 , or P3 ).
If configured, the unit can display four ECG traces on startup, when no other monitoring
devices are attached.
The Propaq MD unit can also cascade a trace onto the adjoining trace area to double the
duration of the trace display.
On the Waveform Display window, to insert a new trace ( Insert ) or cascade ( Cascade ) a
displayed trace, highlight and select the trace label above the trace. In the following example,
the unit is configured to cascade the ECG Lead l trace:
Note: The Propaq MD unit automatically inserts a new waveform when you turn on a
parameter (CO
2
) or a new sensor signal is present (SPO
2
, IBP). The Propaq MD unit
automatically removes a waveform when you turn off a parameter or remove a sensor
and the unit displays the resulting equipment alert.
06/06/2012 12:34:56
Adult
00:17:43
I, II,
III...
12
CO
2
Analyze
IBP
1 cm/mV
II
HR
bpm
80
121
79
(96)
NIBP
mmHg
38
12 BR
CO2
mmHg
SpO2
%
97
T1
ºF
98.6
Pads
III
aVL
aVF
V
Insert
Source
II
aVR
I
Cascade