ZOJE ZJ1900DSS, Manual

Page: 137 / 146

COMPUTER-CONTROLLED HIGH SPEED LOCKSTITCH BAR TACKING MACHINE
- 66 -
E 414
Step Number in Y
Direction Abnormal
After finishing a work,
the main controller finds
the order received by
stepping board in Y
direction is different from
the order of step numbers
given by the main
controller.
415
STEP.2 winding open
circuit
E
416
STEP.2 encoder error
E
417
STEP.1 positional
deviation error
E
418
STEP.2 positional
deviation error
E
419
No.1 current sensor
error
E
420
No.2 current sensor
error
E
412
Y synchronous error
Y sending step is out of
sync with spindle
E 413
Step Number in X
Direction Abnormal
After finishing a work,
the main controller finds
the order received by
stepping board in X
direction is different from
the order of step numbers
given by the main
controller.
E 733 Main shaft over current
Spindle motor
heating and stop
E 739
Mother board IPM
Instant Over-current
Current at mother board
IPM driving module is
too large in short time
E
435
Work clamp foot stepping
motor over-current
447
E
E
Large current is detected
by hardware
Work clamp foot stepping
motor error
Stepping board can not
execution command or
coder error