![background image](http://html.mh-extra.com/html/zoje/zj1900dss/zj1900dss_manual_936875079.webp)
COMPUTER-CONTROLLED HIGH SPEED LOCKSTITCH BAR TACKING MACHINE
- 8 -
2. Attaching the needle
3.
Threading the machine head
Pull out the thread by approximately 4cm from the needle after threading through the needle.
Install
Loosen setscrew
①
and hold needle with
②
the long groove facing toward you. Then
fully insert it into the hole in the needle bar,
and tighten setscrew .
①
If the stitches are made as
shown in "A", attach the
needle facing to the direction
B" to a small extent.
Turn of the power before starting the work so as to prevent accidents
caused by abrupt start of the sewing machine
Turn of the power before starting the work so as to prevent accidents caused
by abrupt start of the sewing machine
1.When the silicon oil is used, thread through thread guide for silicon
①
。
2.For thick thread, pass the thread through one hole only of needle bar thread
guide
②
Summary of Contents for ZJ1900DSS
