COMPUTER-CONTROLLED HIGH SPEED LOCKSTITCH BAR TACKING MACHINE
- 24 -
10. Debugging mode
Via this mode, user can perform the operations of maintenance and checking.
⑴
. When the Sewing LED is off, press
to call the display of
. Then
press
at same time. After the ring of buzzer, the system will have access to
the debugging mode via the user level setting mode of memory switch.
（
Attention
）
Not pressing
at same time will cause the failure of access
to debugging mode.
⑵
. Press
to have access to debugging mode, the monitor will show “CP---” as
displayed in the following picture:
；
⑶
. Press
to perform the display output test. This test will check the display module and
indicator of each LED in cycle; the specific procedure is show in FIgure 1.
⑷
. Press
again to end the display output test. The monitor will display “CP-1” as
shown in the following picture:
.
⑸
. Press
&
to change the program code of the function test. The function stood
by each code is shown in the following table:
⑹
. Hold
to have access to the function test.
⑺
. During the function test, if user presses
, the test will be stopped and the system will
return to the status of 5); However, if the continuous mode has been used for once, the test will
Only after the display output test, can the user perform the test on
other functions.
be unable to be released. For ending the test, the user can only turn off the power.
Summary of Contents for ZJ1900DSS
